Categories

Arrow Safety - Please Read!

  • NEVER FIRE A DAMAGED ARROW

No matter what type, size, brand, or style of arrow you choose to shoot, you must always inspect each arrow for damage before each shot. Proper care of your new arrows can ensure years of quality performance. However, shafts can become damaged, and shooting a damaged arrow is extremely unsafe! Never assume ANY arrow is safe -- not even a BRAND NEW arrow --until you have verified it yourself. It is your responsibility to check your equipment and be sure your arrows are always in good condition.

  • FLEX TESTING ROUTINE - PRIOR TO SHOOTING ANY ARROW

To inspect the arrow for defects, hold it on both ends and flex it away from yourself (and others) while visibly and audibly checking for splinters, cracks, nicks, or dents. Rotate and repeat this inspection several times to make certain the arrow shaft is not damaged in any way. If you find the arrow to be damaged - destroy it immediately. Shooting damaged arrows can result in arrow failure and possible bodily injury.

  • HOW MOST ARROWS GET DAMAGED

Ironically, the reason most arrows get damaged is because modern equipment is simply too good. In years past, the recreational archer was often happy with paper plate accuracy and groups of 4-8" within a typical bowhunting range. But those days are long gone. With modern equipment, even a novice archer can practically pile arrows into the same hole at 20 or 30 yards. Unfortunately, shooting tight groups means there is a chance that an incoming arrow can strike and damage an arrow that's already in the target. If one arrow strikes another, the force of the impact can cause lateral cracks or dents on the arrow shaft. This dramatically weakens the arrow shaft. AND IF YOU DON'T FLEX-TEST all your arrows before shooting the arrows again, you may not detect the damage. So when you fire the arrow again later, it can buckle and snap upon release. This will put your bow hand (the hand holding the bow) at great risk of making contact with the moving segments of the broken arrow. Unfortunately, in a toughness contest between your hand and an arrow shaft, the arrow shaft always wins.

  • ALWAYS SHOOT ARROWS OF SUFFICIENT LENGTH

It is very important your graphite arrows are trimmed to the correct length to match your equipment. Arrows that are too short can become lodged in the arrow rest or behind the riser of the bow (obstructed path). Shooting an arrow that is lodged in a bow or arrow rest in this manner will almost certainly result in arrow failure, damage to your equipment, and/or personal injury. The end of your arrow shaft (not including the tip) should sit approximately 1 inch (2.4 cm) in front of the arrow rest (or more) when you are at full draw. An arrow that is “just” long enough is too short! Please note that changing your bow’s draw length and/or draw stop peg setting (for bows equipped with this feature), will likely change your arrow length requirements. Also, as your bowstring ages and stretches (as all bowstrings do) your bow's effective draw length will slowly increase - particularly if the string set is left in service for an extended period. If you choose not to have your string serviced and replaced at regular intervals, be advised that your bow's arrow length requirements may change over time.

  • ALWAYS SEAT NOCKS PROPERLY ON THE STRING

Before firing your arrow, make sure the nock is properly seated all the way against the string. Be advised that some nocks use a “2-click” procedure, where the nock isn’t fully seated until you hear the second click. Failure to properly nock your arrow on the string may cause the arrow to fall (or partially fall) from the string during the drawstroke. This could result in a dry-fire or an obstructed path shot which could damage your equipment and/or cause bodily injury.

  • SOUTH SHORE ARCHERY SUPPLY ARROW DISCLAIMER

When you buy arrows from South Shore Archery Supply you are accepting full responsibility to adhere to all safety precautions associated with properly handling arrows of any type. You are also agreeing that South Shore Archery Supply, Jerry Ratliff LLC or any of its associates, vendors or manufactures of products sold by South Shore Archery Supply are not responsible in any way for any property damage or injury caused from using a damaged arrow or arrow components.

  • INSPECT AND FLEX EVERY NEW ARROW RIGHT OUT OF THE BOX
  • INSPECT EVERY ARROW PRIOR TO SHOOTING IT EVERY TIME - NO EXCEPTIONS
  • USE PROPER SAFETY GEAR EVERYTIME YOU SHOOT A BOW AND ARROW TO INCLUDE SAFETY GLASSES, PROPER CLOTHING AND KELVAR GLOVES
  • NEVER SHOOT AN ARROW THAT HAS EVEN THE SMALLEST IMPERFECTION TO THE ARROW SHAFT ITSELF OR ANY COMPONENTS OF THAT ARROW
  • NEVER SHOOT GROUPS - NO EXCEPTIONS - ANY ARROW THAT IS SHOT INTO ANOTHER ARROW OR GROUP OF ARROWS SHOULD BE DISCARDED
  • NEVER STORE ARROWS IN A VEHICLE OR GARAGE WHERE THE POSIBILITY EXISTS TO OVERHEAT THE SHAFTS AND COMPONENTS
  • NEVER SHOOT AN ARROW THAT HAS BEEN EXPOSED TO COLD WEATHER BELOW 32 DEGREES FOR ENOUGH TIME TO FREEZE

 

 

<< Mission Statement < Back to List > Conditions Of Use >>
Categories